I have three blanks for sale. These are #2 Teak. They are my first run for practice and have no structural problems, just a few thick glue joints. Just not #1 teak so the grain is not all straight. I have aged them and cut square. They also did not turn out the dimensions I wanted since my original staright edge was not straight. I found that after doing the final checks so I had to cut square again leaving the dimensions just a bit smaller than my original gun build. Asking $125 each plus shipping. If you dont like it return it to me for full refund including the shipping costs.

#1
62 5/8 in length 1 3/8 thick by 1 5/8 high 4 verticle laminates/one horizontal

#2
61 1/8 in length 1 1/4 thick by 1 5/8 high 4 verticle laminates/one horizontal has small blemish where the track route goes, it will be cut away once the track is routed.

#3
60 7/8 in length 1 5/16 thick by 1 1/2 high 4 verticle laminates/one horizontal-SOLD

http://img.photobucket.com/albums/v308/slpcomputer/Woodwork/sale/IMG_1103.jpg

Let me know if you are interested.

Steven 405-401-7748

Did you put what I think is called a rabbit in the Horizontal with a dado in the verticals?

No,

No rabbits or dado cuts. they were laminated verticle under pressure then cut square and had the horizontal laminated with pressure.

They are laminated just like the one in my gun build thread.

http://www.spearfishingplanet.com/showthread.php?t=3709

Come on guys....buy these blanks! He does great work, seen his original gun in person, and it's quality work. You can't beat $125 with a full satisfaction guarantee.

Can't wait for mine to finish curing!